Vetostop SW1 may be positioned by bonding using Vetostop XSW adhesive. Install the Vetostop SW1 either into a groove cast in the concrete or directly onto the concrete surface. Vetostop SW1 can also be fastened by using masonry nails at (250-400) mm centers.
Vetostop SW1 is suitable for use in most weather conditions, but heavy rain or prolonged immersion will cause sudden swelling. Should this occur, it is necessary to allow the Vetostop SW1 to dry out or dry it with a hot air gun before pouring the concrete.
Vetostop SW1 should not be used in expansion joints or any concrete section of less than 150 mm width. No welding is required, Splices are formed as butt- joints or overlapped.
