ڤيتوبرايم آىبي 443

The surface must be sound and thoroughly cleaned before Vetoprime AP443 is applied. All loose particles, old mortar, laitance, dirt, paint, etc., must be brushed off completely with a stiff/wire brush or other suitable means. 

Fungi or Algae should be scoured away using a hypochlorite-type bleach or a proprietary fungicidal solution. Then the surface must be washed with water. Remove all traces of oil and grease with an industrialgrade chemical degreaser or any suitable degreasing agent.

Vetoprime AP443 is used as a penetrating sealer/primer for stone, concrete, and cement-based products. Vetoseal AP443 will reduce/eliminate water and chloride penetration and efflorescence. The sealer is also used to densify weak stone & masonry products.

Ensure that two flood coats (spray, roller, or brush applied) are applied at a rate of 0.7 m²/liter/coat @ 50 microns thickness. Allow for a 2-hour interval between them.

Clean equipment & tools using Vetonit Solvent XX400 immediately after use. In case of residual or cured material, use mechanical means such as a wire brush.