تجاوز إلى المحتوى الرئيسي
Submitted by admin on 16 مايو 2024

ڤيتوبوند 400

غراء لأرضيات كلوريد البولي فينيل (PVC) والـفينيل.

<p>Vetobond 400 is a very low emission, low odor, premium quality, dispersion adhesive designed for laying of various types of vinyl panels/sheets, rubber sheets &amp; various other substrates.&nbsp;</p><p>Vetobond 400 is based on a very special type of synthetic resin, with very highperformance additives, fine grade mineral fillers and tackifier</p>

الاستخدامات

  • Vetobond 400 is recommended for bonding of vinyl covering tiles, carpet tiles, PVC sheet membranes, EPDM sheet membranes, carpets to various substrates, PU foam to concrete, metal and wooden substrates.
  • Vetobond 400 is a high strength dispersion adhesive for vinyl floor coverings, textile floor coverings with a latex, PVC or PUR foam backing, polyolefin sheeting, quartz vinyl flooring, rubber sheets & tiles up to 2.5 mm thickness with a smooth & sanded back.

المزايا

  • Excellent bonding and peel off strength.
  • High compatibility with various backings.
  • Excellent flow and spread properties.
  • Moisture insensitive.
  • Mildew resistant.
  • Non-flammable.
  • Quick setting.
  • Low VOC.
  • Low odor.

تعليمات الاستخدام

The surface should be structurally sound, clean, dry, leveled and free from dust, curing compounds, grease and other loose debris. Keep container closed when not in use.

Apply Vetobond 400 uniformly on the substrate using a fine trowel (Notch A1, A2 or A3). Allow Vetobond 400 to cure for approximately 5-20 minutes before laying the floor covering. 

Lay in the floor covering in the wet adhesive bed, avoid air pockets and rub down carefully. The covering material must be tension-free and lay flat on the substrate, if not then weight it down. 

Floor coverings should be protected from exposure to direct sunlight and from penetration of moisture particularly during the setting phase. 

It is essential to ensure good contact between the floor covering and adhesive. Bonding over existing floor coverings should be avoided. Clean any excess adhesive with water immediately. Do not allow the adhesive to dry. 

Note: Before carrying out floor installation work ensure if the floor temperature and air temperature is above 15°C and relative humidity is below 75%.

تحميل

استكشف المزيد من المنتجات

Plastering Bond

Bonding agent and admixture for render and plaster.

بوند اللياسة

مادة ربط وخلط للياسة والرندر