ڤيتوريب اي ار 352

The surface must be structurally sound, free from oil, grease, and other forms of contamination. The concrete surface should be dry and suitably prepared either by scabbling or grit blasting to remove any surface laitance. 

Grit blast steel surfaces to remove rust and scale.

The Vetorep ER352 kit contains two components, a resin base and a hardener. The kit is supplied & pre weighed in the correct proportions. Do not mix partial quantities. When required for application, mix the two components well until uniform consistency and color are achieved; It’s recommended to use a mechanical mixer for this.

To bond concrete sections, apply an even coat of the product to both surfaces, and bring them together under light pressure. Remove any excess paste which exudes from the joint. Trowel the joint to a neat finish.

Protect the assembled sections from movement until the resin sets. When using Vetorep ER352 as a bonding primer on vertical or overhead surfaces, apply an even layer of Vetorep ER352 to the surface and press it well to ensure good contact. Place the material to be bonded after approximately 1 hour at 20ºC. (This time refers to the total elapsed time from mixing the product).

For patch repairs, apply Vetorep ER352 to the surface and finish it to a level.

Aid smooth surfaces by wetting the trowel sparingly with Vetonit Solvent XX400. Apply Vetorep ER352 to cracks or inaccessible areas using a sealant gun.

Vetorep ER352 has a working time of approximately 2 - 3 hours at 22°C. Don’t leave the mixed material to stand for any length of time before applying it, as it will considerably reduce its working time.

Allow Vetorep ER352 to cure for 24 hours at 20°C before being subjected to foot traffic. At the same temperature, full mechanical and chemical properties are achieved after 7 days (please consult the Saveto Technical Department for further details about curing times at other temperatures).

Clean uncured material with Vetonit Solvent XX400. Remove cured material mechanically.