Stainless Grout

Remove all tile adhesive excess that is at a level higher than half of the tile thickness. All the joints should be free from dust, loose particles and traces of foreign materials, etc. Neutralize the tiles’ water absorption by applying clean potable water. Do not leave water pooling in the joints>

To prepare a mortar from Stainless Grout, pour 5 - 6.4 Liters of water for each 20 kg bag of Vetonit Stainless Grout into a container. Add the powder then mix with a low-speed electric drill fitted with a suitable paddle until a uniform and lump-free consistency is achieved. Remix briefly without adding water.

Blend Vetonit Stainless Grout manually for small quantities but make sure you maintain the correct mixing ratio of powder:water.

If required, add 0.5 Ltr of Vetonit Bond 2 to the mixing water, followed by powder’s addition. Use the mixed material within 1 hour.

Do not add water to the mixture once the mortar grout begins to harden.

Apply Vetonit Stainless Grout using either a rubber blade, a grouting trowel, a rubber spatula, or a sponge.

 Spread the mixed grout diagonally across the tile joints and firmly press it with a rubbing pad covered with a sponge rubber spatula to ensure all the gaps are filled. Remove any excess grout using the same tool.

After the grout initially dries (from 15 - 30 minutes, depending on the ambient temperature and humidity), clean the tiles and remove all excess material with a wet sponge.

After fully drying, clean the surface of the tiles with a dry cloth or disposable cotton towels.

Note: When washing and drying the tiles, ensure not to rub the tile joints too deep Keep the grout moist for the first 2 days after application by spraying the joints with water to achieve the material’s full hardness properties.

For more information regarding the suitable substrates and tiles on which this product can be safely applied, contact Saveto’s technical department.

For further information regarding the suitable substrates and tiles on which this product can be safely applied, please contact Saveto technical department

Clean tools and equipment with water immediately after use. Remove hardened material mechanically