Spatter Dash CB

The substrate should be sound, clean, free from loose material, grease, laitance, dirt curing compound, or any other substance that might impair the substrate’s bond quality.

Add to the mixing container 13.5 - 16 liters of water for each 50 Kg bag of Spatter Dash CB. Add the powder to the water and mix with a mechanical plaster mixer or low-speed electric drill fitted with a suitable paddle. Mix for 3-4 minutes until achieving a uniform, lump-free consistency. 

Blend Spatter Dash CB manually for small quantities and maintain the correct amount of powder to water. Mix for approximately 1-2 minutes until achieving a homogeneous mix.

Preferably, apply Spatter Dash CB in a single coat application to achieve the desired rough thickness of 4-6mm. 

Apply mixed material using a mechanical spray or manual spatter machine or hawk & trowel technique. Cover 95-100% of the surface area to be plastered. 

Allow the installed application to remain undisturbed for at least 48 hours.

Cure Spatter Dash CB by spraying water on the applied materials’ surfaces every 12 hours for a minimum of 3 days. During hot & dry conditions, allow curing for a minimum of 5 days. It will help to obtain high mechanical strengths and minimize the risk of surface cracks.

Clean tools and equipment with water immediately after use. Remove the hardened material using mechanical means.