ڤيتوتوب يو ال 170

The surface should be sound, clean, free from loose material, grease, laitance, dirt-curing compounds, etc. 

Laitance and weak surface layers must be removed using mechanical methods such as grinding or blasting to provide a sound, well-profiled surface. Use an epoxy mortar from the Vetorep ER range to repair all necessary areas before applying. 

New concrete floors should be at least 28 days old with a moisture content of less than 5% (test the substrate’s moisture conditions if an earlier application is necessary).

Mix the base & hardener together for 3 minutes using a slowspeed mixer. Make sure you follow our mixing guidelines and procedures carefully. Scrape the container of any residue and do NOT add solvents at any time.

Apply Vetotop UC370 using a roller or an airless spray. Spray Vetotop UC370 at a thickness of 125 - 150 micron (50% solids), so the application coverage rate is at 3.5 m2/liter per coat (@ 150 microns DFT). 

Do not apply when humidity exceeds 75% or when the temperature of the coated surface is less than 3°C above the dew point.

 Vetotop UC370 can be applied as a single coat or multi-coat sandwich system incorporating Vetograin products to give a slip-resistant finish. For more information, please refer to the Vetograin Technical Data Sheet. 

You can recoat the surface within 24 hours maximum and at a temperature above 25°C only

Expansion joints in the existing substrate must be retained and continued through the Vetotop UC370 topping. Saveto has a range of joint sealants specifically designed for flooring purposes (See the product data sheet of Vetoflex PS782).

Clean tools and equipment with Vetonit Solvent XX300 immediately after use.